I have trouble with 1 node.
Running fine as a gateway, disconnect from switch and won't switch to repeater mode.
I disabled all Lan Block, Isolation etc etc etc
Node comes up on dash with ip, rssi numbers etc.
ssh into gateway, can see the ip address and signals etc but have at <incomplete> on ath0 instead of Mac ID showing..
cannot ping it, dosn't show up on routes, arp is blank.
EOC2610 - firmware 2683.. All other nodes and gateways (2610's & 1650's) run fine...
ANy clues how to get at this unit remotely?..or do I just wait it out