I have an issue with a single node location.
It's role is Repeater, currently running r2683 on an EOC2610 unit. I have changed this unit, re flashed and changed again all with the same result.
I flash, plug into internet, it goes into gateway mode, I let it do its thing for a few hours, ensure its checking in and that it sees other nodes and gateways which it does.. then I disconnect inet and wait and it reverts to repeater mode just fine. I can ssh into it, it sees the gateways, other nodes and updates to the dash without issue. I can alternate physical units and the same behavior. It remains Grey'd out on the dashboard and I cannot ssh into it.. "no route".
I move the node to a new location, plug it in a wait. It has direct line of site to the gateway and there is a node inbetween it and the gateway.
It shows up on the dashboard, gets an IP and other nodes can see it (rssi tables) and the dashboard shows its paths etc. Cannot see rssi numbers when checking from dashboard from this unit and there are no routes to get to it even though all the other nodes and gateways get its ip and signal strength values (high 20's).
Why will it not check in. This unit is 80' to next closet node but with a stronger signal strength. Driving me a little crazy.. Happens when I set the firmware back to 2671 as well...
Curious if anyone has any ideas on whats up?